- April 23, 2017 at 8:10 pm #32092
1) Did you buy everything from here?
a)If you didn’t or changed some things please don’t leave out any details and include what firmware you flashed.
2) Are you using end stops?
a)If so please disconnect them.
3) Mac or PC?
4) Include a picture so obvious errors might be spotted.
Hello how are you, sorry for the inconvenience
I’m building my cnc, it’s 4×4, in total 5×5.
need more cable to get connect my axes to the board
I wanted to get 2 more cables like the Z axis.
Do you know where I can get them?
1 X-axis wire
1 Y-axis wire
MarcosApril 24, 2017 at 3:47 am #32114
I used network cables. One pair per color, I was told it wasn’t really necessary to use both wires per color, but I like the redundancy. Just make sure you use the same color to color scheme on both ends, and use whatever length (within reason) patch cable you need in the middle.April 24, 2017 at 7:01 am #32121
At that size life would be easier if you built the LowRider CNC.April 24, 2017 at 9:04 am #32124
I’m already soldering new cables and spreading.
Next, soon will be the LowRider.
But I need more space in my garage.
Or rent a place to have them …
You must be logged in to reply to this topic.