Yet another Repetier Problem

New Home Forum Software Development Yet another Repetier Problem

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of vicious1 vicious1 11 months, 3 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #10091
    Profile photo of Jamie

    Hi guys,

    Having trouble connecting Repetier Host to MPCNC. Actions so far:

    1. Installed CH340 Windows 8 drivers
    2. Resistor installed on T0
    3. Tried Pronterface – no connection also.
    4. Repetier Server uninstalled
    5. Checked voltages on board

    Using Ardunio Mega/RAMPS 1.4 boards purchased through Vicious site.
    I can make the make the stepper motors move using the RAMPS testing program in Arduino IDE.
    When connecting through Repetier I get a “Connection Timeout’ error. Pronterface just says connecting.

    I would appreciate any help.



    Profile photo of vicious1

    Check your baud rate in repetier, My firmware is set to 250,000, unless you changed it.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.