z-axis bearing bolts

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of 3dTI 3dTI 1 year, 4 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #5167
    Profile photo of Tomi Hautala
    Tomi Hautala

    do you all have the threaded rod so close the bearings?

    i turned those bolts a bit on lathe so that i have little more clearance.

    Profile photo of 3dTI


    I had issues with the threaded rod fouling on the bolt heads too (IE version) but I just spaced the z nut holder out slightly with some washers. Hasn’t caused any issues so far.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.