Z axis questions

This topic contains 2 replies, has 3 voices, and was last updated by  Barry 6 months, 2 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #32824

    John
    Participant

    Should the bottom of the Z axis be able to touch the waste board? If no then I defiantly m a mistake. If it did doesn’t that also mean your going to shorten your CNC by the tool length?

    Thanks

    #32826

    Ryan
    Keymaster

    Usually it can.

    #32827

    Barry
    Participant

    Heh, yea, it should be able to touch. Usually if you really screw up, your cnc will do push ups!

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.