Z-axis stepper

This topic contains 2 replies, has 2 voices, and was last updated by  Ryan 2 years, 1 month ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #3928

    Simon
    Participant

    My z-axis moves incredibly slow and there is no way for me to adjust it. My x and y change with adjustments but the z-axis is incredibly sluggish. I swapped the stepper drivers around and still the same thing.

    #3929

    Simon
    Participant

    Woops sorry but I figured it out with the EEProm settings. Next problem is Z axis steps per millimeter. It says I have gone 300 mm but its more like a half inch. Not sure whats going on…

    #3935

    Ryan
    Keymaster

    Did you buy this from here?

    If not, did you flash the firmware? Be careful swapping drivers they should be at a completely different voltage. There are two speed in repetier for the z axis. Lots of things, if you didn’t get it from here I don’t know where to start.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.